Hello friends!
The Danfoss FC302 inverter is a versatile, high-end inverter commonly used in applications requiring high accuracy, it fully supports communication standards such as ProfiNET, ProfiBUS, EtherNET/IP, Modbus…
Today thelivingchristmascompany.com will guide you to control and monitor Danfoss FC302 inverter via Modbus-RTU protocol by using Samkoon SK-070HS HMI to control it.
Samkoon HMI & Danfoss FC302 “Wiring Diagram”
+ Note: If the communication distance is long (>50m) it is necessary to use a 120Ω terminal resistor on the inverter side
Danfoss FC302 Modbus Parameters Setting
Below are the Modbus-RTU communication parameters that need to be installed for the Danfoss FC302 inverter:
Danfoss FC302 Modbus Registers Address
>>> VFD Control Address = 49999 (dec)
- Set Word 49999 = 1148 (dec) >>> Run Forward
= 33916 (dec) >>> Run Reverse
= 1084 (dec) >>> Stop
= 1212 (dec) >>> VFD Reset
>>> Set Frequency Address = 50009 (dec)
- Speed Reference Setting = 0 to 16384(dec) ~ (0 to 100%)
+ Voltage Output Address = 16119 (dec)
+ Frequency Output Address = 16129 (dec)
+ Speed Output Address = 16169 (dec)
Samkoon HMI “Modbus RTU” Configuration
We have set the Modbus communication parameters for Danfoss FC302 inverter, we also set the same for Samkoon HMI
HMI Programming Example
+ Control Panel
+ VFD Ready Status
+ VFD Running Status
+ VFD Alarm Status
+ VFD Reset Command
+ Frequency Setting
+ Run Forward
+ Reverse Run
+ Stop Command
+ Frequency Output
+ Speed Output
Project Video Tutorial
======
References
>>> Download HMI Samkoon Programming Software
Password Extract: thelivingchristmascompany.com
If you need any support in using Samkoon HMI to control Danfoss FC302 inverter through Modbus-RTU please comment below the article, thelivingchristmascompany.com will reply you as soon as possible.
Thanks and Best Regards!
